Installation Instructions for Pool Signs

Thank you for choosing Pool Signs Australia! Each sign comes with an installation pack containing three fitting options: 4 screws and wall plugs, 4 suction cups, and 4 3M double-sided tapes. Below are the general installation instructions, followed by detailed instructions for each fitting method.

General Installation

Instructions
  1. Prepare Your Tools and Area:
    • Ensure the surface where you will install the sign is clean, dry, and free from dust or grease. A clean surface will ensure the fittings adhere properly.
    • For screw and wall plug installation, ensure you have a drill with the appropriate size bit for the wall plugs provided. For suction cups or tape installation, no additional tools are required.
  2. Mark Placement:
    • Hold your sign against the surface and use a pencil to mark where the fixings should go. Use a level to ensure the sign is aligned properly.
  3. Choose Your Installation Method:
    • Select one of the following three installation options depending on your preferences or the surface type of your pool area. Each method provides secure mounting for your pool sign.
Option 1: Installing with Screws and Wall Plugs
This option is ideal for solid surfaces like brick, concrete, or timber.
Steps:
  1. Mark the Holes:
    • Use the sign to mark the spots for the four screws. Ensure they are positioned correctly and are level.
  2. Drill Holes:
    • Using an appropriately sized drill bit, drill holes into the marked spots. The holes should be deep enough to fit the wall plugs.
  3. Insert Wall Plugs:
    • Gently tap the provided wall plugs into the drilled holes.
  4. Align and Secure the Sign:
    • Align the sign with the wall plugs and insert the screws through the holes in the sign into the plugs. Tighten the screws using a screwdriver until the sign is securely attached to the surface.
Option 2: Installing with Suction Cups
This method is best for smooth, non-porous surfaces like glass, tiles, or acrylic.
Steps:
  1. Clean the Surface:
    • Wipe the surface clean with a damp cloth and ensure it is completely dry.
  2. Attach the Suction Cups:
    • Press each suction cup firmly against the clean, smooth surface. Start from the top and work your way down to ensure proper adhesion. Make sure the cups are positioned at each corner of the sign.
  3. Hang the Sign:
    • Once all the suction cups are securely attached, lift the sign and hang it on the desired location. Ensure the sign is level and stable.
Note: Suction cups are ideal for temporary installation or situations where drilling is not permitted.Option 3: Installing with 3M Double-Sided Tape
This method is suitable for smooth, clean surfaces and offers a quick and non-permanent installation solution.
Steps:
  1. Clean the Surface:
    • Use a clean cloth to wipe down the area where you will install the sign. The surface must be dry and free from dust, dirt, and oils for the tape to stick effectively.
  2. Apply the Double-Sided Tape:
    • Peel the backing off the four pieces of 3M double-sided tape and apply them to each corner of the sign, pressing down firmly to ensure they stick.
  3. Position the Sign:
    • Hold the sign in place against the clean, smooth surface and gently press the sign onto the surface to ensure the tape adheres properly. Apply consistent pressure for about 30 seconds to ensure a strong bond.
Note: This method is ideal for quick installations and temporary signs. It may not be suitable for rough or uneven surfaces.Tips for All Installation Methods:
  • For best results, allow 24 hours before exposing your sign to extreme weather or moisture (especially when using the 3M tape method).
  • Check the sign regularly for stability and reapply suction cups or tape if necessary.
  • When using screws, ensure that the screws are firm to avoid any movement however avoid over tightening. 
If you have any questions or need assistance, please don’t hesitate to contact us at sales@poolsigns.com.au - We’re here to help!